740 for a 940 Engine swap

If I could have about 10 mins of your time what I would like to know is
as follows.

I blew a piston on my 89 Volvo 744 Turbo and bought a 94 Volvo 940
Turbo engine
The only thing I notice as major different is the Distributor.
The 740 has an electerical outlet on it (or a sensor or something) and
the 940 doesn't

will I need swap the ditributor from 740 onto the 940

Also will it be easier to remove the engine with the transmisson on it
or to disconnect the tranny an just pick the motor out?

Thanks Ryan

 

Yes, swap the distributor, you might be able to wire up the crank sensor
instead like the 940 uses but swapping the distributor is likely easier.

In a 700 there's a lot of clearance, it's easier to swap the tranny with
the motor out.

 

Thanks...

I got the engine trany out and notcied the oiler filter is different
with the rad/cooler it's atached to at the front of the engine

Will this be a problem?

 

Swap the oil cooler thermostat and oil filter mounts as well. To use
the stuff on the '94, you need the rad. And with the change from air
cooled oil cooler on the '89 to water cooled oil cooler on the '94, the
intercooler, A/C condenser and some A/C pipes all changed.

--
Mike F.
Thornhill (near Toronto), Ont.

Replace tt with t (twice!) and remove parentheses to email me directly.
(But I check the newsgroup more often than this email address.)