blinker question

Discussion in 'General Motoring' started by Uncle Vinnie, Dec 29, 2006.

  1. Uncle Vinnie

    Uncle Vinnie Guest

    RE: 98 S70

    Where is the turn signal (relay/blinker) located?

    Problem just started, sometimes the directionals blink, sometimes they don't
    at all...my guess, the blinker is on it's way out...

    I've removed the radio, and the compartment under the coin holder.. so it
    must be just behind the hazard flasher..how do you get into there? Am I
    wrong, is it elsewhere?

    thanks!
     
    Uncle Vinnie, Dec 29, 2006
    #1
  2. Uncle Vinnie

    Glenn Guest

    The relay is built in the hazard switch
    Glenn

    --
    "*-344-*Never Forgotten"
    Is for the New York City Firemen who lost their lives on September 11,2001.
    The official count is 343, but there was also a volunteer who lost his life
    aiding in the initial rescue efforts. And I will never forget them as
    long as I live,
    nor should any American.
     
    Glenn, Dec 30, 2006
    #2
  3. Uncle Vinnie

    Uncle Vinnie Guest

    Thanks Glenn, I had a feeling it was in there somewhere... question, how do
    you get in there? Radio compartment or storage- I must be missing
    something!
     
    Uncle Vinnie, Dec 31, 2006
    #3
  4. Uncle Vinnie

    Peete Guest

    Just remove the ashtray and you will be able to push the hazard light
    button assembly in and pull it out through the bottom.

    Peete
     
    Peete, Jan 1, 2007
    #4
  5. Uncle Vinnie

    Mike F Guest

    If you pull out the radio, there's a hole in the bottom of the radio
    box. Sticking your finger through this hole allows you to dislodge the
    hazard switch from its mount, then you can easily pull it out and
    disconnect the wiring.

    --
    Mike F.
    Thornhill (near Toronto), Ont.

    Replace tt with t (twice!) and remove parentheses to email me directly.
    (But I check the newsgroup more often than this email address.)
     
    Mike F, Jan 5, 2007
    #5
  6. Uncle Vinnie

    Uncle Vinnie Guest

    Thanks Mike.. that clears things up a bit! I'll get back in there again!
     
    Uncle Vinnie, Jan 5, 2007
    #6
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.