In Tank Fuel Pump

Discussion in 'General Motoring' started by Ford Fan, Jun 22, 2004.

  1. Ford Fan

    Ford Fan Guest

    I was looking to change my in tank fuel pump on my 89 740 last
    weekend.But ran into some problems.Do I have to remove all (4)
    connections from the sending unit to remove it from the tank? Plus the
    electrical connector? How is the electrical connector hooked to the
    unit? Is it a push on pull off affair or screwed on? Any advice or
    help would be appreciated.
    Thanks Larry
     
    Ford Fan, Jun 22, 2004
    #1
  2. Ford Fan

    Mike F Guest

    Yes, you need to remove all connections. The wire connected to the
    sender is more than 2 feet long. Follow it inside the trunk where it's
    connected to the car harness under the filler pipe.

    --
    Mike F.
    Thornhill (near Toronto), Ont.

    NOTE: new address!!
    Replace tt with t (twice!) and remove parentheses to email me directly.
    (But I check the newsgroup more often than this email address.)
     
    Mike F, Jun 23, 2004
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. 240 in tank fuel pump.?

  2. How does one know when a new fuel pump (in tank) is needed?

  3. 740 Fuel pump tank or under floor

  4. resistors in wires to in tank fuel pump?

  5. changing the in tank fuel pump on a 240 SW

  6. In Tank Fuel Pump 760/780 PRV

  7. Stalling problems -- what's more likely to fail -- fuel pump relay or fuel pump

Loading...