Replacing tie-rod ends on one side...

Discussion in 'General Motoring' started by Jordan B., Oct 1, 2004.

  1. Jordan B.

    Jordan B. Guest

    All,
    I was told by my dealer last weekend that I need to replace the inner
    and outer tie-rod ends on the driver's side of my 1999 S70. It currently has
    110,000 Kms on the odo. My questions are:
    Is this a normal life span for tie-rod ends? I am the second owner and I
    don't know if they have been replaced before.
    Is it normal to only have to replace one side? Shouldn't both sides go
    at the same time? Depends on the driving I would guess.
    Is $340 CDN plus tax too much? That is at a dealer mind you.

    I appreciate any input!

    Jordan 1999 S70 Loaded!
     
    Jordan B., Oct 1, 2004
    #1
  2. Jordan B.

    Rural technologist Guest

    My '95 850 with 200K on it had one side go.
    I had the ball joint + tie rod done for $275
    -p
     
    Rural technologist, Oct 1, 2004
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Tie Rod

  2. tie rod and sway bar replacement

  3. Replacing Rod & Main Bearings

  4. 2 Questions: Tie Rod and Engine Flush

  5. ball joint - tie rod ends

  6. Scantech parts/Tie Rod Assembly

  7. Tie-rod / Ball Joint question

  8. Ball joint and tie rod ends stuck ('93 850)

Loading...