Synthetic Oil...

Discussion in 'General Motoring' started by Your name, Jan 20, 2007.

  1. Your name

    Your name Guest

    Does full synthetic oil deteriorate rubber parts as does regular engine
    oil?
     
    Your name, Jan 20, 2007
    #1
  2. Your name

    Roadie Guest

    You might want to ask one of the major oil companies.
     
    Roadie, Jan 20, 2007
    #2
  3. Your name

    mjc Guest


    My experience - and that of quite a few other people - is
    that synthetic oil doesn't harm new rubber parts, but when you
    switch to it in an engine with old seals that were used with
    standard oil, you are rolling the dice. Japanese cars seem to be
    less likely to develop leaks than Volvos, and not all Volvos will
    develop leaks, but unless you drive an early 850 (these had oil
    distribution and lifter problems that synthetic oil alleviates),
    it really isn't, IMO, worth the risk of switching. Volvo engines,
    especially the "red block" fours, will do just fine on standard oil.

    If you just bought a new Volvo, by all means use synthetic.
     
    mjc, Jan 20, 2007
    #3
  4. Your name

    James Sweet Guest


    Or if you have a turbo, the synthetic is known to be less prone to
    coking up on the shaft, which is one of the primary killers of
    turbochargers.
     
    James Sweet, Jan 20, 2007
    #4
  5. Your name

    Mr. V Guest

    Go here, and check out the forums.

    http://www.bobistheoilguy.com/

    None better for your type of question.
     
    Mr. V, Jan 21, 2007
    #5
  6. Your name

    Ed Guest

    This is the last word.... No, but if you have seals that are sealing
    because of a build up of crud, the synthetic might clean out the crud
    and you'll leak
     
    Ed, Jan 21, 2007
    #6
  7. Your name

    Your name Guest

    Thank you for your input.
     
    Your name, Jan 21, 2007
    #7
  8. Your name

    Your name Guest

    Thank you for your input.
     
    Your name, Jan 21, 2007
    #8
  9. Your name

    Your name Guest

    Thank you for your input.
     
    Your name, Jan 21, 2007
    #9
  10. Your name

    Your name Guest

    Thank you for your input.
     
    Your name, Jan 21, 2007
    #10
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.