Wheel stud replacement on model with ABS

Discussion in 'General Motoring' started by Duong Nguyen, Oct 8, 2004.

  1. Duong Nguyen

    Duong Nguyen Guest

    The removal of the studs on the front wheel of my 760GLE seems to be
    blocked by the ABS disk located just behind the hub. I haven't
    actually looked at the car but the picture in Hayes seems to indicate
    that either ABS disk needs to be removed or the whole hub+ABS must be
    replaced. I'm not entirely sure since the picture is not very clear. I
    was hoping to replace the stud without removing the hub. Does any know
    if this is possible? A related question is what kind of tool (that I
    can buy or hire) do I need to remove the stud. Is a hammer OK? Is it
    possible to make up a tool if none is available commercially?

    Can wheel stud thread be re-threaded?
     
    Duong Nguyen, Oct 8, 2004
    #1
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. safety vs. model number, model year for US volvos

  2. OEM ABS control unit or Aftermarket ABS control unit?

  3. '89 240 DL Wheel Stud Replacement

  4. V70 ABS wheel sensors

  5. V70 - 1997 - ABS wheel sensor

  6. Replacement tires for a 1999 S70 non-turbo model...

  7. Do I need 2 or 4 wheel alignment on a front wheel drive car?

  8. Exhaust Stud Treatment?

Loading...