850 ABS-unit failure in hot weather after first resoldering?

  • Thread starter Thread starter franz47
  • Start date Start date
It is not a trivial thing. Many people are lucky and get by. I few
people know what they are doing and get it right every time. I worked
for AT&T Bell Labs and our technicians could tell when an engineer did a
solder job. I was an engineer and usually got it right. The
technicians got it right every time.
Click to expand...

It´s done now. I went to a local electronics repair shop, yes very few of them
are still around nowadays here, chatted quite a time with the guy there. He
resoldered it for a reasonable price, told me that it was a nasty job to get the
contacts cleaned. He suggested to istall it first preliminarily to check
function and heat tolerance, all ok now, so today I sprayed the
electronic-circuit-sealant onto the circuit, sealed the lid with a silicone like
high temperature resistant sealant, changed the screws and hopefully will never
never have to bother about the unit.
Thanks again for any input
Franz47, Vienna, Austria
 
You must log in or register to reply here.
Back
Top